Average Reviews:
(More customer reviews)For those looking for research on this product it is hard to find. Below is a little about the product.
-10 gauge per wire
-The microfiber is only around the small wires
--Microfiber must come off before installation and can be removed with finger nails
-Thick and heavy, looks like a 1 or 2 gauge power wire
-Remove the 3 outer layers one by one with an exacto knife
--mesh: cutting motion, use a piece of tape to keep the mesh intact.
--thin outer tubing: light pressure all the way around then once down the middle
--thick inner tubing: lightly press the middle of the knife into it all the way around then down the middle. Work slowly here, as you don't want to cut the wire tubing.
-Remove the individual wire tubing with a 10 gauge stripper. Be careful as there are not many stands of copper
*stripping the wire will most likely take 10-15 min per strand.
The copper wires are thick too. Very good quality. Would recommend with any subwoofer installation. It's something you may even want to show off.
5m is more then enough for two subs within the trunk.
-Keven
Click Here to see more reviews about: Monster MPC S402 SW-250 Extreme Low Noise 2-Conductor Speaker Wire (250 feet)
Whether the thump of house music or the roar of rocket engines, subwoofers add depth and realism to your favorite music,movies and video games. But to get the deepest, tightest bass possible you need to accurately transfer low frequency signals to your amplifiers with maximum efficiency. Specifically engineered for frequencies below 80 Hz and featuring Monster\'s most advanced XLN Xtreme\' construction, QuadraPole and PEX\' dielectric technologies, Monster Performance Car 400 Series Subwoofer Interconnects maximize signal transfer and minimize noise pickup for intense sound with deep, tight, heart-pounding bass.
0 comments:
Post a Comment